







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Kitchen Remodeling: The Vallejo Owner’s Guide
We install KraftMaid cabinetry in Vallejo at $14,000 – $45,000 for a full kitchen remodel, with cabinet installation alone running $4,000 – $13,000. That price is written before any work starts. KraftMaid is the brand most of the readers on this page already own or already chose, and the same set of failures turns up again and again in Vallejo houses: a cabinet door that will not sit flush after two summers, a drawer that rubs the frame on one side, a hinge that has wallowed out its pilot holes, a box whose side panel has bowed away from the face frame. In our experience, most Vallejo KraftMaid calls are not about a broken part so much as a cabinet line that has moved, a hinge way out of alignment, a door that was never squared to begin with, or a few small localized problems that have been avoided for years. We work with KraftMaid cabinetry as an independent service provider, not as KraftMaid or any part of its dealer network. The sections below walk through what actually fails, what replacement and adjustment cost in Vallejo, and where the line sits between a job you can handle and one to hand off.

Which KraftMaid Models This Applies To
KraftMaid boxes its cabinetry into a handful of construction tiers, and the tier decides how a repair goes. The stocked lines (the ones sold through home centers) use particleboard or MDF boxes with stapled joints and particleboard shelves. The full-access lines run plywood or engineered box stock with glued and mechanically fastened corners and adjustable, thicker shelving. Door and drawer fronts swap between the tiers in some door styles and refuse to swap in others: hinge bore spacing, door thickness, and overlay size (standard overlay, full overlay, and inset) all change by line. A door from the wrong line will bolt onto your hinge plate and then sit crooked against the face frame. Before ordering anything, read the label inside the cabinet box (the manufacturer prints the line, the door style, and the finish code there), then measure the door stile width and the hinge bore centers. We work from those measurements, not from photographs. We also match finish codes against KraftMaid’s current offering, because a “Bisque” from one run is not always a “Bisque” from another. When a line or finish has been discontinued, we quote a quality aftermarket door or drawer front built to the same bore spec and overlay. It looks right when it is shut alongside the original, and it costs less than trying to track down a discontinued part.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your KraftMaid Kitchen Remodeling Is Failing
- Doors that will not stay shut or stay flush. The hinge plate has loosened, the screw has torn through the cabinet-side wood, or the hinge has lost spring tension. In an older KraftMaid cabinet the screw holes commonly strip first.
- Drawers that bind, tip, or drag on one side. Undermount slides come off their clips, the drawer box is out of square, or the front was never squared to the box. In Vallejo, we see this badly on drawers that take the heaviest daily use, like the one under the coffee maker or the trash pull-out.
- Boxes that have pulled away from the wall or gone out of square. Attic heat through the ceiling and the two-to-three-month dry run of a Vallejo summer will dry a box out and let it shift. Once the box is out of square, every door and drawer on it misbehaves, no matter how carefully you adjust the hardware.
- Water damage at the sink base or under the dishwasher. A slow leak or a failing P-trap swells the particleboard and delaminates the finish. Vallejo kitchens that run the dishwasher daily and never look behind the toe kick tend to find this before they find anything else.
- Doors and drawers that no longer match each other. A sun-facing door has faded, or a later repair used the wrong finish. That is a materials problem, not a hardware problem, and it changes the scope of the job.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Replacement and repair pricing in Vallejo follows the scope, not the brand label. Here is what we install, and what each line includes:
| Work | Vallejo price range |
|---|---|
| Full kitchen remodel, KraftMaid cabinetry | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation (KraftMaid) | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
Every line brings its own labor, waste, and finish-matching cost. A single replacement door or drawer front is a small job; a full KraftMaid reface with new fronts across a 12-door kitchen and the countertop cut to match is a different number. What moves the quote: how much of the run needs to come out, whether the boxes are reusable, whether the plumbing or electrical has to move, and whether the door style or finish is still available from KraftMaid. Everything is itemized in the written price. There are no change orders at the door. The completed work is covered by the 365-Day Done Right Promise, which means a written guarantee for a full year; if a cabinet fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
You can safely tighten a loose hinge plate, add a screw where the plate has loosened, reattach a drawer that simply slipped off its clip, and clean out the underside of a sink base to find a leak before it spreads. That is the whole list of sensible homeowner work on a KraftMaid kitchen.
The dangerous part starts with the rest. Pulling a cabinet run off the wall involves the countertop, the plumbing, and the gas stub behind the range; a gas line is a job for a trained, permitted professional, not a weekend. If your kitchen has a gas range, a gas cooktop, or a gas wall oven, the rough-in goes back together with a licensed plumber or gas fitter. We pull the permits and pass the inspection on that work. If a cabinet box has swollen from a leak or gone out of square, the fix is a new box, not another turn of the screwdriver. We work with the KraftMaid cabinetry line, but we do not keep stock of KraftMaid parts or carry parts on a truck. When a door or drawer front is needed, we measure it and order it against the KraftMaid line, or source an equivalent. To talk through your situation, call (844) 560-4789. A real person answers, 24 hours a day, and the estimate is free.
FAQs

A KraftMaid box installed correctly and kept dry usually gives 20 to 30 years, and the hardware is the first to go. Hinges and drawer slides wear out long before the boxes do, so expect to replace them two or three times across the life of the cabinet. Finish on a sun-facing run will fade before the wood gives out. Maintaining the cabinets and correcting leaks quickly will get you to the top of that range. Call (844) 560-4789 for a free estimate on the work you are considering.
Most hardware failures can, and a failing hinge or slide is usually a repair rather than a replacement. Adjusting the hinge, plugging and re-driving a stripped screw, or swapping a slide is normal maintenance. A swollen box, a delaminated door face, or a run that has pulled out of square is not a repair; those are replacement jobs. We will tell you which category you are in after we look at it. Estimates are free, and (844) 560-4789 is answered by a real person.
A single door or drawer front swap is often under an hour of work, but the part itself waits on KraftMaid to ship it. A full cabinet installation, which is the $4,000 – $13,000 line on this page, typically runs several working days depending on the layout and whether countertops and plumbing are involved. We give you the schedule with the written price, and we hold to it. The 365-Day Done Right Promise covers the finished job for a full year. Call (844) 560-4789 to schedule a free estimate in Vallejo.
We measure the door or drawer front against the cabinet label inside the box: line, door style, finish code, bore spacing, and overlay. Then we order the part from KraftMaid if the line and finish are still active. If they have been discontinued, we quote an aftermarket door or front built to the same spec. This is why the measurement matters, and why a photograph will not do.
We also work with Cambria, Silestone, and Kohler alongside KraftMaid, so a new door does not have to sit next to a counter that was cut for a different cabinet run. That matters when the replacement cabinet has a different depth or height than the one it replaces. Call (844) 560-4789 and we will walk through the fit in Vallejo.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












