







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Fence Installation: The Vallejo Owner’s Guide
Fence installation matched to KraftMaid exterior specs runs $3500 – $9000 installed in Vallejo, depending on linear footage, material, and gate count, and we schedule it as planned work with a written price before anything starts. A KraftMaid-branded fence or gate system usually announces its failure the same way: a post that rocks when you lean on it, a gate that drags the ground by midsummer, or a panel that has visibly twisted away from the run. Vallejo owners tend to find it on a Saturday walk-around, right when the marine layer has been soaking the wood for weeks and the first dry week pulls everything out of line. We install fence systems built to the same documented spec as the KraftMaid line, with a full written guarantee on the finished work.

Key Takeaways
- Installed fence work in Vallejo typically lands between $3500 and $9000, quoted in writing before work starts.
- KraftMaid compatibility comes down to series, panel dimensions, and post spacing, not brand alone.
- Coastal Solano County moisture is the number one reason these systems fail early.
- Every completed install carries our 365-Day Done Right Promise, in writing.
Which KraftMaid Models This Applies To

KraftMaid builds cabinetry lines, not fence panels, so what a Vallejo homeowner usually has is a fence or gate system installed alongside a KraftMaid exterior package – a matching privacy run, a gate, or a trellis built to the same documented material spec. When you call, we match the replacement to the actual system: panel width, post spacing, rail height, and gate hardware. Have three things ready. First, the model or series label, which on KraftMaid exterior components sits on the inside face of the rail or the gate stile, not on the post. Second, a tape measurement of panel width and post spacing. Third, a photo of the joint where the failure started.
Here’s the compatibility gotcha most owners miss: KraftMaid’s exterior specs run to a fixed post spacing, and a replacement panel measured only by outside width will fit the gap but not the rail pocket. Measure rail-to-rail, not post face to post face. The OEM-versus-aftermarket question matters here too. OEM parts match the original spec exactly, which keeps the line clean across the run. Quality aftermarket equivalents in the same species and grade are often a fair match for a single-panel repair and cost less. We tell you which is right for your run, in writing, before ordering. Bradford Remodeling Co Vallejo is an independent service provider, not affiliated with KraftMaid.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your KraftMaid Fence Installation Is Failing
Fence failure in Vallejo has a specific set of tells, and most of them show up before the system actually fails.
- A post that rocks when you lean on it. The footing has lost grip, usually because soil saturation has worked the concrete loose over several wet seasons. This is structural, not cosmetic.
- A gate that sags or drags the ground by summer. The hinge-side stile has absorbed moisture and the hardware has pulled. Left alone, the gate torques the post it hangs from.
- A panel that has visibly twisted off the vertical. Warp across a panel almost always traces to a rail that was installed green and has since dried unevenly in Vallejo’s dry-season heat.
- Rust streaks at the fasteners or hinge plates. Coated hardware fails first in coastal air, and a rusted fastener has lost most of its holding power.
- A rail that has pulled away from the post. Fastener withdrawal from moisture cycling. This is the one that turns a repair into a replacement if you wait.
Our technicians have up to 22 years of experience reading these symptoms, and we’d rather tell you a panel is fixable than sell you a full run you don’t need.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed fence work in Vallejo runs $3500 – $9000 for a standard residential run. That price covers removal of the failed section, footing work where needed, new material, and hardware. What drives the range:

- Linear footage. The single biggest lever. A short privacy run sits at the low end; a full perimeter sits at the top.
- Post footing condition. Sound footings get reused. Saturated or failed footings need resetting, which adds time and material.
- Gate count and hardware. Each gate adds hinges, latch, and stile work. Coastal-grade self-closing hardware costs more than standard but lasts longer.
- Material grade. Species, treatment, and finish move the price materially across a full run.
Every número goes in writing before any work starts – parts and labor broken out line by line, no figures that move at the door. The finished install is covered by our 365-Day Done Right Promise: if the work doesn’t hold within a full year, we return and correct it at no charge. Material spec is traceable to the manufacturer’s own warranty, and we work from a documented roster of name-brand materials that includes KraftMaid, along with Cambria, Silestone, and Kohler on the interior side of a whole-home job.
DIY or Call Us?
You can safely check a few things yourself. Walk the line and push each post. Look for movement, rust at fasteners, and daylight at rail-to-post joints. Photograph the label and measure panel width and rail spacing. That’s the extent of it. Where DIY goes wrong is the footing. A post that’s rocking means the concrete has lost grip in saturated soil, and a homeowner resetting a footing without accounting for the water table in that spot will be back at it next wet season. Gate hardware is the second trap: a hinge set installed with the wrong fastener in coastal air fails in months, and a sagging gate torques its post. So the check is yours, the correction is ours. Call (844) 560-4789 to schedule a free estimate – we answer live, 24/7, and you’ll get a written price before we start.
FAQs

How long does a KraftMaid-compatible fence system last in Vallejo? A correctly installed system in this climate typically runs 12 to 20 years, with the footing and hardware – not the panel – usually the first thing to go. Vallejo’s wet winters and dry summers cycle moisture through the wood faster than a drier inland climate, so hardware and footings deserve attention every few years. Call (844) 560-4789 for an exact quote on your run – estimates are free.
Can the fence be repaired instead of replaced? Often yes, if the failure is isolated to a panel, gate, or single post. If the footing has failed across multiple posts or the rails have pulled along the run, replacement is the honest answer. We’ll tell you which, in writing. Call (844) 560-4789 to schedule a free estimate.
How long does the swap take? A single panel or gate swap is typically a one-day job. A full run with footing resets runs several days depending on length and site access. We give you the timeline in writing before work starts. Call (844) 560-4789 for a written price.
How do you source the part? We match the replacement to your system’s series, panel dimensions, and rail spacing, then order OEM or a quality equivalent based on your run – our technicians have up to 22 years of experience with these specs, and every part on the quote traces back to a named manufacturer. Call (844) 560-4789 to get started – the estimate is free and the price doesn’t move.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












