







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Roofing: The Vallejo Owner’s Guide
Therma-Tru is a door and entry-system manufacturer, not a roofing manufacturer, so there is no Therma-Tru shingle, underlayment or flashing kit. What Vallejo homeowners actually call us about is the roofing and weather-sealing work around a Therma-Tru door installation: the head flashing, the sill pan, the threshold seal, and the trim and soffit above a new or failing entry door. That work runs $400 to $1,800 for repair-level corrections and $8,000 to $20,000 when a full roof replacement is the honest answer, and we quote it in writing before any work starts.

Owners usually find the problem the same way: a dark stain spreading across the ceiling near the entry, a door that suddenly sticks in wet weather, or daylight visible at the top corner of the frame after a hard rain. Vallejo gets its rain in concentrated bursts between October and April, and a small flashing gap that stays dry all summer will show itself in the first two storms of the season.
Which Therma-Tru Models This Applies To

Therma-Tru makes entry doors, patio doors and sidelight systems under lines like the Classic-Craft, Fiber-Classic, Smooth-Star and Traditions families, and the roofing detail matters most on any door with a transom, a sidelite, or an exterior overhang above it. To identify what you actually have, open the door and look at the hinge-side jamb for the manufacturer’s label; it lists the series and the unit size. Measure the rough opening width and height in inches, not the door slab, because the flashing and sill pan are sized to the frame, not the panel.
Here is the compatibility gotcha that trips up homeowners ordering online: Therma-Tru sill pans and threshold extensions are keyed to specific sill profiles, and a pan sized for one series will not seat correctly on another even when the width matches. The other issue is that many Vallejo homes built before the 1980s have an entry recessed under a shallow porch roof with minimal overhang, which means the flashing has almost no room to shed water. On those, the correct fix is often a fabricated metal head flashing rather than a stock part. As an independent contractor we work with Therma-Tru products but are not affiliated with Therma-Tru, so we specify by measurement and label rather than by brand assumption.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Roofing Is Failing
- Water staining on the ceiling or header above the door. This points to failed head flashing or a gap where the wall meets the roof plane, letting water track down the framing instead of off the roof.
- The door sticks or drags in wet weather. A swollen jamb or a shifted threshold usually means moisture is getting behind the frame, not that the door itself has gone bad.
- Peeling paint or soft trim above the entry. Trim and soffit board above a door take the runoff from the roof above them; when they stay wet, the substrate behind them starts to go.
- Daylight or a draft at the top corners of the frame. That is a seal or flashing gap, and it lets both water and air in. It shows up most on windy rain days.
- Granule loss or curling shingles directly over the entry. Localized wear above a door often means the flashing detail was done poorly the first time and water has been working at the edges.
In Vallejo we regularly see these failures on the north and west-facing entries, where the prevailing winter weather hits hardest and the surfaces dry slowest.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Roof repair around a Therma-Tru entry in Vallejo runs $400 to $1,800 depending on how much flashing, sheathing and trim has to be replaced. A tile roof repair runs $600 to $2,500 because tile matching and careful lifting of surrounding courses add labor. If the damage is widespread, a full roof replacement runs $8,000 to $20,000, and a metal roof installation runs $15,000 to $40,000.
What drives the range: whether the flashing is stock or has to be fabricated, how much rot is found once the trim comes off, roof pitch and access, and whether the work needs a permit. Our written price itemizes parts and labor separately so you can see what you are paying for. Every completed project carries the 365-Day Done Right Promise: if the work fails within a full year, we come back and correct it at no charge. Your signed guarantee is in your hand at job close, along with a clean site and a documented scope.
DIY or Call Us?
You can safely check a few things yourself: look for stains on the ceiling near the entry, run a hand along the trim above the door for soft spots, and check the Therma-Tru label on the jamb so you know the series. Photograph the flashing above the door from the ground if you can, and note where the water shows up.
Where DIY goes wrong is up on the roof. Roof work means height, and wet shingles and tile are slick. Lifting courses to redo flashing without breaking surrounding material takes technique, and a flashed detail that looks right from the ground can leak for another season. This isn’t a part you swap with a screwdriver; it is roofing work that has to shed water correctly. Call us at (844) 560-4789 and we will look at it and give you a written price.
FAQs

A properly flashed and sealed entry detail should hold 15 to 25 years in Vallejo’s climate, and the trim and paint above it need attention roughly every 7 to 10 years. The failure is almost always the sealant and flashing, not the door system itself. Call (844) 560-4789 for an exact quote; estimates are free.
Yes, most of the time. Localized flashing and trim repair resolves the issue when the damage hasn’t reached the sheathing or framing, which is the $400 to $1,800 range. Once rot reaches the framing, a larger scope is the honest call. We’ll show you what we find before you decide. Call (844) 560-4789 for a free estimate.
A repair-level correction is typically a one-day job, and a full roof replacement runs several days depending on square footage and material. We give you the schedule in writing with the price before work starts. Call (844) 560-4789 to schedule your free estimate.
We specify by measurement and label, and we source Therma-Tru-matched flashing, sill pans and compatible roofing materials through documented suppliers so the specs are traceable. We don’t claim to carry parts in stock or on a truck; the correct part is ordered to your door’s actual dimensions. Call (844) 560-4789 and we’ll walk you through it.
If you have a Therma-Tru entry and water showing up around it, the fix starts with an honest look and a written number. We also work with KraftMaid, Cambria and Silestone on the interior side. Bradford Remodeling Co Vallejo answers the phone with a live person, 24 hours a day, seven days a week, and our technicians have up to 22 years of experience. Call (844) 560-4789 to schedule your free estimate.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












