







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Home Additions & ADU: The Vallejo Owner’s Guide
If you’re planning a home addition or ADU in Vallejo and want Therma-Tru doors specified into the build, the installed scope typically lands in the $45,000 – $130,000 range for a home addition and $90,000 – $220,000 for a full ADU, with a garage conversion running $30,000 – $80,000. Those numbers include the door package – entry, patio, and interior slabs – carried out to Therma-Tru’s factory framing specs so the rough openings, thresholds, and weather seals are correct the first time.

Owners usually arrive here after a door problem shows up mid-project. A Therma-Tru fiberglass entry on a three-year-old addition starts sticking at the strike plate in August. A multi-slide patio door won’t close flush because the addition’s floor settled an eighth of an inch. Or a sidelite seal lets in rain during a Vallejo storm and the foam core wicks moisture from the bottom rail up. These are framing and installation signals as often as they are part failures – and in an addition, that distinction decides whether you’re replacing a component or correcting the structure around it.
Which Therma-Tru Models This Applies To

Therma-Tru entry and patio doors show up across the product lines Vallejo homeowners most often spec: the Fiber-Classic and Smooth-Star entry series, the Classic-Craft line with its varied panel profiles, and the patio door lineup including hinged, sliding, and multi-slide configurations. Each line carries its own rough-opening requirements and threshold heights, and those numbers must match the addition’s framing before a single door is ordered.
To identify what you have, look for the manufacturer label on the hinge jamb or the top of the door slab – it lists the model, series, and handing. If the label is gone, measure the slab width, height, and thickness to the nearest sixteenth of an inch and note whether the unit is left- or right-handed. That measurement set is what a supplier needs to match the part.
The OEM-versus-aftermarket call matters here. Therma-Tru’s own components are built to the exact tolerances of the series, and for structural pieces like the frame, sill, and threshold, genuine parts are the safer match. For hardware – handlesets, hinges, weatherstrip – quality aftermarket equivalents from established brands are often fine and cost less. In an addition, the parts that carry the weather and structure are where we don’t cut corners. We’re an independent contractor and not affiliated with Therma-Tru; we work with their products because the specs are traceable.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Home Additions & ADU Is Failing
- Sticking at the strike plate or top corner. Usually a sign the addition’s framing has shifted or the door was hung slightly out of plumb. Seasonal swelling in humid Vallejo summers makes it worse.
- Daylight or draft around the perimeter. Failed weatherstrip or a threshold that isn’t seated against the sill. Left alone, it pulls conditioned air out of the addition and drives up your energy bill.
- Water staining or soft wood at the bottom rail. A failed sidelite seal or a threshold that traps water. Fiberglass doors resist rot, but the frame and sill behind them don’t – and coastal moisture finds the weak point.
- A patio door that won’t slide or latch smoothly. Worn rollers, a bent track, or settling that threw the opening out of square. Common on multi-slide units in additions built on Vallejo’s older clay soils.
- Fogging between the glass panes. A broken seal in the insulated glass unit. The door itself is fine; the glass assembly needs replacing, and it’s a component swap rather than a whole-door job.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Therma-Tru door component in a Vallejo addition or ADU, budget by scope. A hardware or weatherstrip refresh runs roughly $150 – $450 installed. A threshold or sill replacement lands around $300 – $900 depending on series and whether the frame needs work. An insulated glass unit swap runs $400 – $1,200 per door. A full entry door replacement installed is $1,200 – $3,500, and a patio or multi-slide unit runs $2,500 – $7,500.
What drives the number: the specific Therma-Tru series, whether the rough opening needs correction, hardware grade, and glass options. Every quote is a written, line-item price before any work starts – parts and labor shown separately, no numbers that move at the door. The work is backed by our 365-Day Done Right Promise: if a repair or install fails within a full year, we return and correct it at no charge. Our technicians have up to 22 years of experience with door systems and additions.
DIY or Call Us?
You can safely check your own door: confirm the model on the jamb label, measure the slab, test the latch, and look for daylight or water staining. What you shouldn’t take on alone is reframing a rough opening or resetting a door that’s out of square in a load-bearing wall – that’s structural work, and getting it wrong in an addition means water intrusion and a door that never seals. Pulling a heavy multi-slide patio unit out of its frame without the right equipment is a two-person injury risk.
Verdict: the inspection is yours, the structural correction is ours. Call (844) 560-4789 and we’ll give you a written price before anything is touched.
FAQs

A well-installed Therma-Tru fiberglass entry door typically lasts 20 to 30 years, but the seals, weatherstrip, and insulated glass fail far sooner – often within 8 to 12 years in a coastal climate with Vallejo’s humidity swings. Call (844) 560-4789 to have yours assessed; estimates are free.
Often yes. Weatherstrip, hardware, thresholds, and glass units are all replaceable components, and a repair usually costs a fraction of a new door. If the frame or slab itself is damaged, replacement makes more sense. Call (844) 560-4789 for a straight answer on which yours needs.
A component swap like hardware or glass takes a couple of hours; a full entry door replacement is usually a one-day job, while a multi-slide patio unit in an addition can run two days if the rough opening needs correction. Call (844) 560-4789 for a schedule based on your door.
We match the part to your door’s labeled model and series, then order the genuine component or a verified equivalent. Nothing is guessed from a photo. Call (844) 560-4789 and have your model label ready – we’ll confirm the match and the price in writing.
Beyond Therma-Tru door systems, we also work with KraftMaid, Cambria, and Silestone on the interiors of the additions and ADUs we build throughout Vallejo. If your project needs a crew that runs on discipline and puts the price and the guarantee in writing, that’s how we work – The Garrison Standard, every job.
Ready to price your Therma-Tru addition or ADU work? Call (844) 560-4789 for a free estimate. A live person answers, 24/7, and you’ll have a written price before a single tool comes out.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












