







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Driveway & Pavers: The Vallejo Owner’s Guide
We install Boral driveway and paver systems across Vallejo, and a typical installation runs $7,000 – $18,000 depending on square footage, base prep, and which Boral line you choose. If you’re here because a paver has cracked, heaved, or dropped, you’re in the right place. Most Vallejo owners first notice it as a single rocking paver near the driveway apron, or a hairline crack that spreads after a wet winter. By the time a rut or a sunken corner shows up, the base under the Boral surface has usually been moving for a season or two. This guide covers what fails, what a correct replacement costs here, and how to tell whether you’re looking at a paver swap or a full rebuild.

Key takeaways:
- Boral pavers themselves are tough; failures in Vallejo are almost always base or drainage problems, not the paver.
- Installed paver driveway pricing runs $7,000 – $18,000. Spot repairs are far less.
- We write the price before any work starts and back the work with the 365-Day Done Right Promise.
- Bradford Remodeling Co Vallejo is an independent contractor and is not affiliated with Boral.
Which Boral Models This Applies To

Boral makes pavers in several families, and the one on your driveway matters for matching color, thickness, and edge profile. Common ones you’ll run into on California driveways include the Boral Stoneworks and Belair lines, plus interlocking and rectangular profiles sold under regional names. Paver thickness is the first spec to check: 60mm is standard for pedestrian and light-driveway use, while 80mm is what you want under vehicle traffic in a driveway application. If you measure 60mm pavers under a driveway that sees two cars daily, that’s a compatibility gotcha worth knowing before you order replacements.
To identify your paver, pull one from an edge or a corner, flip it, and look for the manufacturer stamp on the underside. If there’s no stamp, measure length, width, and thickness in millimeters and note the color and texture. Take a photo with a tape measure in frame. Bring that to us and we’ll match it to the closest current Boral profile. Boral discontinues and renames lines over the years, so an exact OEM match isn’t always available. In that case we’ll tell you plainly and show you the closest quality aftermarket equivalent, so you can decide whether to blend in a near-match or replace a whole field for a uniform look. We don’t claim stock, and we don’t carry parts on a truck. What we do is source the right paver and quote it in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boral Driveway & Pavers Is Failing
- Rocking or loose pavers. The paver has lost its bedding sand and is sitting on a void. This is the earliest, cheapest-to-fix sign, and it almost always traces to base settlement or water getting under the edge.
- Heaving or lifting sections. A section that lifts in winter points to water trapped in the base and expanding as it freezes and thaws. In Vallejo’s wet-season swings, poor drainage at the driveway apron is the usual culprit.
- Hairline cracks spreading across pavers. Cracks through the paver itself usually mean point-loading from an unstable base or a paver that was laid too thin for the traffic. A single cracked paver is a swap. Cracks following a line are a base problem.
- Sunken ruts where tires track. Ruts under the wheel path mean the compacted base has lost density. This one doesn’t get better with sand and sweeping; the base has to be re-graded and re-compacted.
- Sand washing out at edges and joints. Joint sand disappearing after rain signals the driveway is shedding water toward the house or street instead of away from it. Left alone, it undermines the edge restraint and the whole field starts to spread.
One thing worth saying plainly: our technicians have up to 22 years of experience, and the pattern we see most in Vallejo is a failure that looks cosmetic at the surface but is structural underneath. That’s why we don’t quote a paver swap until we’ve seen what’s below it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest range for paver work in Vallejo, in writing, before any tool comes out:
| Work | Installed range |
|---|---|
| Paver driveway installation (full) | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement (existing removed) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What drives the number: square footage, how much existing paver and base has to come out, whether the base needs re-grading or a new compacted aggregate layer, edge restraint and drainage corrections, and the Boral line you choose. Parts and labor are quoted as separate line items, so you see the paver cost and the install cost side by side. Every completed job carries the 365-Day Done Right Promise: if the work fails within a full year of completion, we come back and correct it at no charge. That’s a written guarantee in your hand at close, not a verbal promise.

DIY or Call Us?
There’s a safe middle ground here. You can absolutely pull a loose paver, check the stamp, measure it, and photograph it. You can rake joint sand back into a joint and see if it holds through a rain. You can check whether water pools at one corner and note where it drains. That’s diagnosis, and it’s useful.
Where DIY goes wrong is the base. Re-setting a paver over a soft spot without re-compacting the aggregate underneath means it rocks again within a season, and you’ve spent the weekend twice. Cutting pavers, setting edge restraint, and getting the slope right so water leaves the driveway is the part that separates a fix from a repeat. The paver isn’t the dangerous part; the base is the expensive mistake. If you’ve got a single cracked paver or a section that’s moving, call us at (844) 560-4789 and we’ll give you a written price on the repair before anything starts.
FAQs

The pavers themselves commonly last 25 to 50 years; the base underneath is what decides how long the driveway actually performs. In Vallejo’s wet winters, a properly compacted base with good drainage is what keeps pavers from heaving and settling, and that’s where most premature failures start. Call (844) 560-4789 for an exact quote on your driveway; estimates are free.
Often yes, if the failure is isolated: a single cracked paver, one rocking unit, or a small sunken section can usually be lifted, re-bedded, and re-set. If the problem runs along a line or shows up in the wheel path, it’s a base issue and a spot repair will only buy you time. We’ll tell you which one you’re looking at before you commit. Call (844) 560-4789 to schedule a free estimate.
A typical driveway replacement in Vallejo takes several days to about a week, depending on square footage and how much base work is needed. We give you a written schedule with the written price, so you know the scope and the timeline before the crew arrives. Call (844) 560-4789 for your free estimate.
We identify your paver from the manufacturer stamp on the underside or from exact measurements and a photo, then match it to the closest current Boral profile. If an exact OEM match isn’t available, we show you a quality aftermarket equivalent and let you decide. We don’t claim stock or parts on a truck. Call (844) 560-4789 and we’ll start with your photo.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.
Bradford Remodeling Co Vallejo installs Boral-compatible hardscaping and works with a documented roster of premium brands including KraftMaid, Cambria, and Silestone. Every job gets a written price before work starts, a background-checked and uniformed crew, and the 365-Day Done Right Promise on completed work. Call (844) 560-4789 for a free estimate; a live person answers around the clock.












