







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Home Additions & ADU: The Vallejo Owner’s Guide
We install Quikrete-compatible home additions and ADUs in Vallejo, with standard additions running $45,000 – $130,000 and full ADU construction at $90,000 – $220,000, priced in writing before we touch a tool. Quikrete doesn’t make additions or ADUs; it makes the bagged concrete, mortar mix, and repair products that go into the foundation, slab, and masonry tie-ins of an addition. So what we’re really matching here is the Quikrete product to the pour it has to feed and the code it has to pass. Vallejo homeowners usually discover the problem a different way: a patio slab or old foundation edge in the yard is cracking and crumbling, they read a bag of Quikrete at the hardware store, and they start wondering whether a concrete repair is the beginning of a real addition project or a doomed cosmetic patch.

Which Quikrete Products This Applies To

This guide covers the Quikrete products that show up in a home addition or ADU build: Concrete Mix (the red bag, high-strength for footings), Sand/Topping Mix for shallow repairs, Fast-Setting Concrete for post and footing work, Mortar Mix for block and brick, and Concrete Resurfacer for worn slab surfaces. The homeowner question we hear most is which bag matches the job. The real answer depends on pour thickness, load, and what the existing concrete is doing.
How to identify what you’re working with: read the bag label for psi rating and set time, and measure the cracked or shallow area before you buy. Concrete Mix is labeled for structural footings and slabs; Topping Mix is for 2 inches or less; Fast-Setting is for a footing where you can’t wait overnight for cure. If you’re trying to match an existing slab, the mix in the original pour matters more than the bag color. A few things we consistently see in Vallejo:
- A Vallejo slab poured in the 1950s or 1960s may be a leaner, softer mix than a modern high-strength bag. Patching it with a modern high-psi mix can leave a hard cap over a soft base and crack along the seam within a season.
- Fast-Setting Concrete sets in about 20 – 40 minutes. That’s the right product for a fence-post footing poured on a Saturday; it’s the wrong product for any footing you need to level and adjust. Once it kicks, it’s done.
- Mortar Mix and Concrete Mix are not interchangeable. Using Concrete Mix to set block is a common DIY slip; the block joint can fail under Vallejo’s winter wet-dry cycling. Mortar Mix is what the joint requires.
- Concrete Resurfacer bonds best to a clean, roughened, damp slab. Slap it on a dusty or sealed surface and it delaminates within a year. The prep matters more than the bag.
On OEM-versus-aftermarket: for concrete and mortar, Quikrete is the OEM-grade product most crews specify, so the choice is rarely brand substitution; it’s which Quikrete product line fits the pour. A general-purpose bag from another maker won’t match a footprint or a pour requirement you’ve already set.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Concrete or Foundation Footing Is Failing
- Hairline cracks that widen season to season. The cause is usually a footing that moved or a slab poured too thin, not the surface. Sealing over it hides the symptom; it doesn’t restore the base.
- Crumbling or chalky surface at the slab edge. Freeze-thaw cycling in Vallejo’s wet winters can spall a soft mix. Resurfacer can cover it; it won’t fix an under-strength base.
- Masonry block joints that pop or hollow out. A joint set with the wrong mix (concrete instead of mortar) goes brittle and separates from the block. The block moves; the joint opens.
- A footer or post base that rocks or lifts. A footing poured with fast-setting mix before the post was leveled leaves a lean that gets worse over years. Any structure sitting on it inherits the lean.
- Delaminating resurfacer on a walk or driveway. This almost always traces to prep: a dusty, sealed, or wet-cold slab never bonded. The surface flakes within one Vallejo wet season, and the flake pattern tells you the bond never existed.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

An addition or ADU is a full construction scope, not a parts swap. The installed ranges we quote in Vallejo:
- Home Addition: $45,000 – $130,000
- ADU Construction: $90,000 – $220,000
- Garage Conversion: $30,000 – $80,000
- Driveway / slab replacement where relevant: $5,000 – $14,000
What drives the range: footprint and square footage, footing depth and soil conditions, whether the existing slab can be reused or has to be demolished and repoured, framing and finish level, and permit scope. Quikrete concrete and mortar are a small line item in the total; the labor, engineering, and inspection work is the bulk. We give the full written price before any work starts. The 365-Day Done Right Promise covers the finished work for a full year: if it fails inside that window, we come back and correct it at no charge to you. Permits are pulled by us and inspection sign-off is part of the job close.
DIY or Call Us?
Some Quikrete work is genuinely owner-level. Patching a small cosmetic crack, resetting a loose paver with a little topping mix, filling a fence-post hole: a homeowner can do that with a bag and a trowel. Where it goes wrong is at scale. A footing, a slab tie-in for an addition, or a block wall is structural work, and a bad pour doesn’t show up until the next wet season or the next inspection. We’d rather you not gamble on the structure that holds the addition. Our technicians have up to 22 years of experience, and our installs use documented, name-brand materials throughout (KraftMaid, Cambria, Silestone, and others). Call (844) 560-4789 for a free estimate on the structural scope. We’re independent and not affiliated with Quikrete; we simply install the products correctly.
FAQs

A properly poured and cured high-strength Quikrete Concrete Mix footing will outlast the structure above it, typically many decades. What shortens it is under-mixing, pouring too thin, or using fast-setting mix and then raining it in before it’s set. Inspection at pour time is the real lifespan factor.
Sometimes, yes. A shallow surface failure under 2 inches can take a Quikrete Sand/Topping Mix or Concrete Resurfacer repair if the slab underneath is sound. If the slab is cracked through to the base or has heaved, patching it won’t hold, and the honest call is a repour. We’ll tell you which one you’re looking at on site.
A garage conversion runs shorter, often weeks depending on finish level; a full addition or ADU runs months, with footing and slab work in the first phase. We give the schedule in the written scope before work starts. Call (844) 560-4789 for the timeline on your specific footprint.
We buy Quikrete products through normal supplier channels and match the product line to the pour: high-strength Concrete Mix for footings, Mortar Mix for block and brick, Topping Mix for shallow repairs. We don’t keep parts on a truck; the right bag is ordered for the job. Call (844) 560-4789 to schedule your free estimate.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












