







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Techo-Bloc Fence Installation: The Vallejo Owner’s Guide
We install Techo-Bloc fence systems in Vallejo, and most residential projects land between $3,500 and $9,000 installed. That number covers the modular wall block, footing, caps, and full assembly of a Techo-Bloc-branded fence – a segmental retaining wall system built to fence height, not a wood or vinyl panel fence. It is planned work, so we schedule it and give you a written price before the first tool comes out; we don’t promise same-day installs on a masonry fence and you shouldn’t believe anyone who does.

Owners in Vallejo usually find a problem the same way: a run of block leans a few degrees out of plumb after a wet winter, or the cap course rocks when you press on it, or you spot a cracked unit near a corner where the wall turns. On sloped lots around Hiddenbrooke and the hills above Tennessee Street, the first warning is often a gap opening between courses on the downhill side. All three point to the same underlying issues: a footing that wasn’t dug deep enough, drainage that was never designed, or block units set without the proper interlock.
Which Techo-Bloc Models This Applies To

Techo-Bloc builds several segmental wall series that get used as fencing, and the series matters because the block dimensions and the interlock geometry differ. The Mini-Creta and Creta lines are the common residential choice – narrow, textured units that stack into a clean vertical wall. The Semma and Brandon series are heavier, larger-format block used where the wall carries more load or where the lot is graded. What you’re checking is the block’s face width and depth and its interlocking lip or pin system, because a replacement or addition has to match the same series or the courses won’t key together.
To identify what you have, look at the back of a cap unit or lift one block and read the casting marks; Techo-Bloc units carry a series identifier and often a plant code. If the marks are worn, measure a single block face to the nearest eighth of an inch and compare it against the series spec sheet. Buying an aftermarket “equivalent” block is where Vallejo owners get burned: a block that’s a quarter-inch off in depth will not seat with the existing lip, and the whole run has to come apart. We match the actual series, not a lookalike. We’re an independent installer and not affiliated with Techo-Bloc; we source their products through normal distribution channels the same way we source KraftMaid, Cambria, and Silestone for our interior work.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Techo-Bloc Fence Installation Is Failing
These are the symptoms we actually see on Vallejo fences, and what’s usually behind each one:
- The wall leans out of plumb, often toward the street. That’s a footing or base-course failure, or soil that’s pushing from behind because there’s no drainage relief. On a segmental wall, a lean of more than a couple of degrees over a full run means the base was never set level.
- Caps rock or lift at the edges. Cap units are usually adhered with construction adhesive, and when they loosen, water gets behind them and freezes or expands. Loose caps are the early warning for a wall that’s taking on water.
- Block units crack, chip, or spall at the face. Spalling is surface flaking, and in Vallejo’s wet winters followed by dry summers, block that was set with poor drainage and no relief will spall along the face where water sits.
- Courses separate or open a gap on a slope. That’s the interlock failing, usually because the wall was stacked without the proper lip engagement or the base course wasn’t compacted.
- Soil or gravel washes out at the base after rain. Water is running through the wall instead of around it, which means the drainage gravel and weep points were never installed or are clogged.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Vallejo, replacing a failed Techo-Bloc fence run typically runs $3,500 to $9,000 installed. The range moves on three things: the linear footage and wall height, whether the existing footing has to be excavated and replaced, and how much regrading or drainage work the lot needs. A short run on flat ground at the low end; a longer wall on a graded lot with footing replacement at the high end.
Every quote is a written line-item price before work starts – block and caps, footing excavation and pour, drainage gravel and relief, labor, and haul-off – so nothing moves at the door. The install work carries our 365-Day Done Right Promise: if a footing, cap, or course we set fails within a full year, we come back and correct it at no charge. The written guarantee goes in your hand at job close, along with a clean site and a documented scope.
DIY or Call Us?
A segmental fence wall is heavy, load-bearing work, and the part most likely to fail is the one you can’t see: the footing and the base course. What you can safely do yourself is inspect and document – check for plumb with a level, look for loose caps, note where water pools at the base, and read the series marks to identify your block. What you shouldn’t do is lift and restack courses to chase a lean, or dig out and re-pour a footing. Block units weigh far more than they look, a wall under soil pressure can shift without warning, and a footing set too shallow will fail again the next wet season. That’s the work for a trained crew. If your wall is leaning, cracked, or washing out at the base, call us at (844) 560-4789 for a free estimate and we’ll tell you honestly whether it can be stabilized or needs a rebuild.
FAQs

A properly built Techo-Bloc fence should hold for decades – block itself doesn’t rot – but the real lifespan is set by the footing and drainage, and in Vallejo’s wet winters a wall built with a shallow footing and no relief often shows failures inside the first five years. The block lasts; the base is what fails. Call (844) 560-4789 for a free estimate if your base is washing out.
Often yes, if the problem is isolated – a few loose caps, a short run out of plumb, or clogged drainage can be corrected without tearing the whole wall down. A wall leaning along its full run or a failed footing almost always needs the base re-done. We’ll give you a written price for either path so you can compare. Call (844) 560-4789 for a free estimate.
A typical residential run takes several days, not one – footing excavation and cure, then block setting, caps, and drainage, and the footing has to set before block goes down. Exact timing depends on footage and site access. We give you a written schedule with your written price. Call (844) 560-4789 for a free estimate.
We identify your series from the casting marks and block measurements, then order through normal distribution channels to match that series exactly – no lookalike aftermarket block. We’re an independent installer and not affiliated with Techo-Bloc. Call (844) 560-4789 for a free estimate and we’ll confirm what series you have.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












