







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Driveway & Pavers: The Vallejo Owner’s Guide
We install Wellborn-compatible driveway and paver systems in Vallejo, and a full paver driveway installation here typically runs $7,000 to $18,000, with sealing from $250 to $700. Most owners don’t call us because they read a spec sheet. They call because a joint has started heaving, a paver has cracked through its face, or water is pooling against the garage slab after rain. That pattern of failure is what tells us whether the base, the bedding course, or the paver itself is the real problem, and it’s the first thing we walk through on a free estimate.

Vallejo sits on some of the most variable ground in the Bay Area. The flats near Mare Island Strait are filled and shrink-swell heavy, while the hillside streets toward Vallejo Heights and the older neighborhoods around downtown carry decades of settled subgrade under their driveways. A paver that looked fine at installation can wander out of line in two or three wet seasons if the base wasn’t built for that soil. Knowing which part actually failed matters more than replacing pavers on top of a bad foundation.
Which Wellborn Driveway & Pavers Systems This Applies To

We install Wellborn paver and hardscape lines that match the manufacturer’s current specification sheets, and we work from the model and series information on your original documentation. If the paperwork is gone, the part numbers and series identifiers are usually stamped or molded on the underside or edge of the paver itself, so pull one from a hidden course near the garage apron or along a planter border rather than from the middle of the field where wear has obscured the mark. Take two measurements with a tape: nominal face size and actual thickness. Both matter.
The OEM-versus-aftermarket decision breaks along a clear line. For a straight replacement in the field, a quality aftermarket paver matched on thickness, compressive strength, and color family will perform under the same conditions if the base is sound. For border courses, steps, or any transition detail, we source the original Wellborn profile because the tolerances there are tighter and a near-match shows. That’s a spec question, not a sales one. We do not claim to keep parts in stock or carry them on a truck, and we don’t pretend to. We identify the right part and source it to the specification before we quote. Driveway replacement in Vallejo runs $5,000 to $14,000 depending on how much of the footprint needs rebuilding.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Driveway & Pavers System Is Failing
- Heaving or lipping at the joints. One paver sitting proud of its neighbor almost always means the bedding layer has lost support underneath, not that the paver itself is defective. Frozen and re-thawed ground or a poorly compacted base causes it.
- Hairline cracks through the face. A crack that runs edge to edge usually points to a base failure that flexed the paver, or to point loading from vehicles parked consistently on the same spot. Surface crazing versus a structural crack are two different repairs.
- Water pooling along the garage or foundation. Standing water after a storm means the slope has flattened or the paver field has settled, and that water is now working against the slab. This one shows up fast in Vallejo’s wet winters and is worth a look before spring.
- Sand washing out between joints. Missing joint sand lets the pavers shift and invites weeds. Usually it’s a drainage issue or worn polymeric sand, but it can also signal the base is moving.
- Color fade and surface spalling. UV exposure and freeze-thaw cycles wear the face over time. Spalling (flaking of the surface layer) on a Wellborn paver often traces back to chloride exposure or a base that trapped moisture.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the straight number. Paver driveway installation in Vallejo runs $7,000 to $18,000 installed. A concrete driveway lands between $4,500 and $12,000, asphalt paving between $3,500 and $9,000, and full driveway replacement between $5,000 and $14,000. For an existing paver field, driveway sealing is $250 to $700 and is often the right first step if the base is still solid.
The range is driven by footprint square footage, how much base and subbase must be excavated, whether the existing drainage needs regrading, and which paver series you select. We give a written, line-item price before any work starts, non-negotiable, no exceptions. Parts and labor are separated so you can see exactly what the material costs and what the installation costs. Every completed driveway and paver project carries the 365-Day Done Right Promise: if the work fails inside a full year, we come back and correct it at no charge. We work with documented, manufacturer-backed hardscape brands including Belgard and Unilock, and our technicians have up to 22 years of experience.

DIY or Call Us?
What an owner can safely do: pull a loose paver, photograph the base and bedding under it, measure thickness and face size, and note where water pools after rain. That information is genuinely useful and helps us quote accurately.
Where DIY on a driveway goes wrong is the base. Replacing a paver on top of a failed bedding layer or an unexcavated subgrade just kicks the same failure down the road, and a re-bedded paver that isn’t compacted to spec will lift again the next wet season. Getting the compaction, the slope to drain, and the edge restraint right on a Vallejo driveway with these soils is not a Saturday afternoon job. If a paver came loose cleanly and the base beneath is intact and firm, we’ll tell you so and you can put it back. If you’re seeing any of the symptoms above, call us at (844) 560-4789 and we’ll take a look on a free estimate before you spend the afternoon.
FAQs

How long does a Wellborn paver driveway last in Vallejo? With a properly compacted base and edge restraint, a paver driveway here lasts 25 to 30 years, though the joint sand and sealer need refreshing every few years. Vallejo’s wet winters and those shrink-swell soils make base quality the deciding factor, not the paver.
Can it be repaired instead of replaced? Often yes. If a handful of pavers are damaged or shifted and the base is sound, we pull, reset, and re-sand the affected area at a fraction of a full replacement. If the failure is widespread or water is pooling against the slab, replacement of a section is usually the honest answer. Call (844) 560-4789 for a free estimate and an exact quote.
How long does the swap take? A section repair usually takes a day to two days. A full driveway replacement typically runs three to five days depending on footprint, base depth, and drainage work. We tell you the schedule in writing with the price.
How do you source the part? We identify the Wellborn series and profile from your documentation or the mold marks on the paver, then source to that specification from a documented manufacturer supply chain. We don’t stock parts and we won’t guess at a match, because a mismatched border or transition shows immediately. KraftMaid, Cambria, and Silestone are among the other brands we also install.
Do you pull the permits on a driveway project in Vallejo? Where the scope triggers it, yes, and we’ll tell you at the estimate whether a permit is required for your driveway work. Our technicians are background-checked and uniformed, and a live person answers the phone 24 hours a day, seven days a week.
Written by the team at Bradford Remodeling Co Vallejo, serving Vallejo and nearby areas.












